Record and report the packet’s path (IPv4).įor the ping attempt. The number of requests, include the count option. Ping requests are sent before the results are reported. Not in individual messages for each ping request. The results are reported in a single message, (Optional) Specify a hexadecimal fill pattern to include The remote system you are trying to reach.ĭo not attempt to determine the hostname that corresponds to the IP (Optional) Ping the physical or hardware address of (Optional) Intermediate loose source route entry (IPv4). (Optional) Name of tenant system from which to send To return to the main router or switch, enter The defaultĪlternatively, enter the set cli logical-system logical-system-name command and then run the ping command. Of values, in seconds, is 1 through infinity. (Optional) How often to send ping requests. Header) is greater than the MTU, the ping operation might fail. Therefore, if the ping packet size (including the 48-byte In Junos OS Release 11.1 and later, when issuing the ping command for an IPv6 route with the do-not-fragment option, the maximum ping packet size is calculated by subtractingĤ8 bytes (40 bytes for the IPV6 header and 8 bytes for the ICMP header)įrom the MTU. Is identified as IPv6 Ping when destination is IPv6 address or inet6 option is used.įor Junos OS IPv6 packets, this option disables fragmentation. Set the do-not-fragment (DF) flag in the IP header of the ping packets.įor Junos OS Evolved Release 18.3R1, IPv6 ping does In the output the interface on which the ping reply was received. Option is not supported for Junos OS Evolved Release 18.3R1. Value is an unlimited number of requests. (Optional) Number of ping requests to send. The command output displays the connectivity information of the CEĭevice based on the configured routing instance type. Name of the VPLS or EVPN routing instance. Loopback address as the source for a specific VPLS or EVPN routing To use the CE device IP address as the target host and the PE device Ping infrastructure, where the ping utility is extended Private LAN service (VPLS), hierarchical VPLS (H-VPLS), and Ethernet Points, and MAC addresses, from a provider edge (PE) device in a virtual Information of customer edge (CE) devices, such as reachability, attachment Routers with MPC and MIC interfaces only) (Optional) Check the connectivity Local system through an interface that has no route through it.Ĭe-ip destination-ip-address instance routing-instance-name source-ip source-ip-address If the system is not on a directlyĪttached network, an error is returned. IP address or hostname of the remote system to ping.īypass the normal routing tables and send ping requests directly toĪ system on an attached network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |